«Circle Lines» (Prototyping: Laser Motion Control with LeapMotion, Processing and Arduino). from Armando Rodriguez on Vimeo.

This video shows the prototyping process for one of my newest works. I’m using firmata to create an interface between arduino boards wich controls the position of the servo motors and a software developed in Processing. This software recives leapmotions’s signal and interprets as an specific position for every motor, this system allows to create an interactive experience.

I used two arduino uno, and one leap motion sensor. The software allows to control many servos as the arduino board can and is possible to connect more than one board to the computer (USB). I’m planning to use this system as an interactive installation in the future.

Blog: armyrdz.wordpress.com